Engine Swap

[Build] [Mechanics] [Electrics] [Megasquirt]

Currently running:
• V3.0 MS1 with High Resolution MS1 extra firmware (hr_10d)
• errors* daughterboard
• Innovate LC1 wideband lambda controller

Which makes the following functions available: 12x12 fuel and advance table, COP and wasted spark support, over-run fuel cut, tacho output, launch control, spark cut rev limit, boost control, table switching, AFR target tables.

Plans to go to MS2 extra and looking for a way to log without the laptop.

Links:

- MegaSquirt
- MegaSquirt Success Stories
- Megamanual
- MS1/Extra Manual
- MS2/Extra Manual
- GPIO board from Bowling and Grippo
- DIY AutoTune

Additional information:

Ignition:

The hardware described: link

I do not know how to get the exact dwell timing with the COP's :-(. Current settings are working but if somebody knows the values pls. contact me

Idle control:
The throttle body supports a partly opening of the valve by placing +12V on pin 1. The MS is equipped with a TIP122 transistor (link), so it is not needed to use a relay to control the throttle valve.